Help trying to run a program designed in mach 3 , trying to run on fire control ,
trying to run a cut program desighned in mach 3 on fire control any recommendations. Did shut of thc still starts first cut thc lifts up and runs progrm with torch lifted up strong text
Hi Stan,
I think the easiest route for you would be to take the .TAP file and run it through a 3rd party program to extract the DXF and run it through your post process as you usually would… It’s a free program and open source… See this thread—>
you would need to pre-process the dxf/svg file.
if you use sheetcam and saved the job, you should be able to open it back up and re-process it using the firecontrol PP.