Took a few pictures of a few cuts I made tonight making the laptop stand. The main frame was .200” and the stiffener were .125”. This was the first cuts I made with my razor weld 45. Had some slight issues with the cuts on the thicker stuff I was running 50ipm but some of the circles didn’t cut clean. Don’t know if it was too fast torch too high or low. Even looking bad the dross did for the most part chip right off. Some of the cuts had a pretty heavy bevel.
7 Likes
@bsulley22 looking good. Did you draw that up yourself?
Yes I did wasn’t too hard hopefully I can get it welded up today.
Here’s a short clip of part of it
6 Likes
@bsulley22 outstanding! looking good! I cant wait till mine comes in hopefully soon:grinning:
1 Like