Just wondering about a few things

[Knick]

@curmudgeon

The feed screw on the Z axis assembly where it travels thru the plastic (nylon?) initial torch height “block”; does that need to be kept lubricated? I am very fond of Fluid Film but also know that it can swell certain plastics. Does anyone have any ideas on this?

I have a XR and I’m not sure if its the same nut or not, I just lube with a little motor oil or #2 grease, I have not had any trouble.

@curmudgeon

Does anyone know if that new and improved version of the dimple die that D&N Custom Creations made is still floating around out there?

Here is the Dimple die thread

Bar sink drain dimple die

Just got the dies 2 hours ago from frizz and used them. I’m ready to send them out. Whoever is next please send me your address. Terry TLD1948