I looked for an answer before posting, I could not find anything.
Fire Control is installed and seems to be working but I dont see anything on the Visualator part
Current setup.
Everything is assembled except for, no water in the table and the torch is not attached.
I ran through the break in program and all seemed fine but did not see anything in the Visualator section. Pulled up a file I have been working on and tried running that (Dry Run) and I got the same thing.
LOL
When I read your replay I wanted to reply, I looked and could not find it.
But being embarrassed that could be the problem I went and looked again. It took a few minutes to find but I got it.