I did? I am just responding to replies on this thread and asking people how they personally handle it, as it may vary person to person. Sorry, I am new to posting on the forums here so maybe I am using them wrong…
1 Like
Sounds good, appreciate the insight!
Your fine, it’s all good.
Your fine I have done the same thing before its easy to forget. Some times there are so many people trying to help, all with different advice that it gets a little overwhelming
And as far as pierce delay goes the advice for an XR is different than the advice for a pro that’s why you might get some conflicting information.
I can set the Pierce delay to 0.1 on my XR and it will fire where the lowest I could ever set my pro was 73% of the 0.5 second delay.
My minimum latency on my pro is .37 seconds. I normally only go this low if I’m cutting 26 gauge galvanized, 14 gauge stainless or center marking.
2 Likes
That explains why I can get away with 0.2s on my XR.
1 Like