It’s been a while since I’ve been on the forum, but curious how those with PowerMax 30Air cutters have been fairing? I’ve cut a handful of pieces since I bought the table (maybe 50 or so pieces), and find myself fighting the plasma cutter a lot. The torch will just cut out and the machine throws a torch error. I suspect it’s due to the non-shielded consumables. Seems like anytime a little bit of water gets on top of the sheet and the torch passes through it, it shuts down (motion control continues). Likewise if any metal splatters onto the cutting tip. I’ve wasted so much metal due to this issue it’s driving me crazy. I’m to the point where I’m thinking about selling the 30Air and switching to a 45XP. Anyone else having similar issues?