The fine folks at Langmuir beat me to the punch. The cable above is the one I ordered. Like it says, plug and play. I see that you ordered the machine torch, that’s a GOOD thing. No need to mess with rewiring the hand held so it works with the CPC interface. It is literally plug and play. Be aware though, the machine torch does NOT come with any consumables. Here’s the list of stuff you need to get going:
Mechanized Consumables
Standard Cutting Consumables
Shield 220817
Retaining Cap 220854
Nozzle 220941
Electrode 220842
Swirl Ring 220857
The hand torch uses:
Standard Consumables
Standard Drag Cut
Shield 220818
Retaining Cap 220854
Nozzle 220941
Electrode 220842
Swirl Ring 220857
Make sure you put the business end of the torch together correctly. It’s in the manual under the machine torch section. Believe it or not, I had my swirl ring in upside down, trust me it will cause problems.
Also, the standard torch holder will not hold the machine torch. Either buy the one Langmuir has or make one. I used 1/4 and 5/15 aluminum plate. If you have access to a mill it’s an easy part to make. I should have bought the Langmuir one, it’s prettier than mine… Kind of like the red…
My table is now up and running as of today. Played around with it a bit, now it’s all about dialing in settings etc.