How can I make Mach3 pause after each cut?

[Burgs04]

You can change the dwell time between cuts. It will pause for the time you set.

Increasing motion delay for tip-up management

Hi All, I address this in another thread but feel compelled to post this in a standalone thread. The current CrossFire V1.1 Mach3 configuration has the torch pause motion for 1 second after completing a cut before moving onto the the next cut. If you are finding that one second is not enough time to identify a tipup and command a feed hold, you can increase the delay by doing the following: In Mach3, click on Configuration–>Ports and Pins–>Spindle Setup Change the CW Spind Down Delay from 1 t…