Help...which wires from cut 60 to thc box?

[TinWhisperer]

@Jimmyjames86

need some help with the wiring from the primeweld cut 60 to the thc box.

While a lot of people have had success running divided voltage from the primeweld’s CPC port, others have not.

The most reliable source for the THC voltage measurement (RAW) comes straight from the lugs with inside the prime weld.

Here’s a PDF outlining the procedure from @nicaDd

https://forum.langmuirsystems.com/uploads/short-url/rzFqfMZGINy0QhCQW2GQgET1vq2.pdf

Going this direction you would use the other pathway through the voltage input module (VIM)

You could also use a port like this

Prime weld cut 60 wiring questions using divided voltage

It is a clean install but so why such a large port for 2 wires? Why not have the vim installed inside the plasma cabinet and then use a small barrel connector port instead for the divide single output from the VIM? Then all the full dc voltage wires will be contained in the plasma cabinet. Just a thought I wanted to throw out there. [51Da7Gfqy5L.AC_SL1000] [51xCJfXyvwL.AC_SL1000] [51oMaKi1KhL.AC_SL1000] A few examples Edit Or leave the vim In the plasma Cabinet and use the factory CNC por…

instead of running the wires through the louvers of vent cover would make install the little cleaner.

Prime weld cut 60 wiring questions using divided voltage

Wow! Makes me glad I did the raw voltage. My brother is using the divided voltage with his CF-Pro table with no problems for him so far. Here’s my installation. The PV out goes to a female barrel plug with a dust cap at the back. The VIM box is mounted inside the case which I like. I’ll be testing this weekend. Thanks for your assistance (and everyone else too)! [20250102_203658] [20250102_211445] [20250102_211549]

@KevinB how is your installation and the prime world been holding up for you?