I tried to cut something today and this is what firecontrol is doing. Any ideas?
I an using the same laptop (new when i bought the table). This is the first time I’ve seen this with no cross hairs parts, machine and show machine doesn’t work.
When i load a program it doesn’t show any pic just the gcode. It will run the gcode but i don’t know were the part is just seeing the torch moving in dry run.
Haven’t seen that specifically, but under your view window there is a tab that say Machine. Your pic looks like its off. Try clicking on it to enable.
Those don’t do anything (the three in the middle ), but all the others work .
In the upper left, there should be a drop down menu with “show visualizer” in there. Make sure it’s checked.
That fixed it . Thanks
I feel pretty stupid , i worked on that for a long time yesterday. Was going to unhook my desktop computer this morning and take it to the garage but i don’t have to do that now ( that’s good). thank you very much.
Your a troubleshooting machine!