Fusion 360 is not generating a toolpath for holes smaller than 1/2 inch. Any suggestions?

[TinWhisperer]

@BeyondWelding13 welcome to The forum

Fread this post and see if it satisfies some of your questions.

One or more passes is discarded due to linking constraints? SOLVED

@jrck.21 Welcome to The Forum What one or more passes we’re discarded for linking constraints means. The pass is what everyone else in the world but Fusion would call the path, A loop or line being cut in Fusion. Now the Linking constraint is found in the 2D profile menu in the linking tab. Linking constraints are lead ins, lead outs, lead in radii, Pierce clearance, etc and the other factor that affects this is kerf width. So the problem is is all these linking parameters add up enough the fu…