Came in about midway. Great idea. Thanks for the effort.
Lead-in/out decisions are a topic that I still struggle to understand. So many of the parameters are defined in a cut chart or machine specs, but there is some situational decision making to be done on the leads. I don’t yet have enough experience to deduce my settings.
Even though I’ve read a lot of threads where it’s discussed, it’s usually just advice about changing the parameter until it works. Not a lot about how to set it correctly based on conditions of the cut that make it critical to get them correct.
There was one helpful (to users like me) thread about cutting from the center of the hole. Maybe add that info to your video (apologize if it’s covered in 1st part of video).
Cutting from the Center of a Hole: Fusion 360 - Software / Fusion 360 - CAD - Langmuir Systems Forum
Thanls again. I look forward to the next installment.