So with my expanded table I swapped the X and Y axis.
The Y axis works fine standing in front of the table, but now the X axis is reversed.
Is there a way to change this in mach 3?
Basically if I press the left arrow it goes right and right arrow goes left.
With the steppers on my 3d printers all you have to do is reverse the input (wires).
Yah I am trying to avoid that especially since there is 4 wires, I have no idea what does what and its far more work than editing it in mach 3.
Disregard, I found it!
Under config, homing settings.
Don’t forget to change your table size in there too so you see what’s available and not a lot more or less. I think it defaults to 100x100" if I remember right.
Reversing it homing actually didn’t change anything.
Whether it’s checked or unchecked nothing happens?
Had you run the table prior and ir was correct or is this the first time?
There were a few boxes that went out mis wired. that reversed the axis.
I will see if I can find thread
This thread shows the red and green wires. swapping position will switch direction.
My table is a little out of the norm now. I rebuilt the entire thing but in that process i intentionally reversed what was X and Y and doing that just
Happened to make X backwards as well.
I was able to correct the issue in Mach3 settings config motor outputs.