Cutting speeds and amps

So. I have mixed results.
Using the x45 torch and the razorweld 45, on 14 or 16 gauge steel, I sometimes get alot of dross. Sometimes its really clean… using 80-90 IPM and 30-32 amps.

Anyone else have really good results with a specific setting for 16 or 14 gauge steel?

I know my air supply is top notch. Just poking around, trying to save myself some “post cut time”

I’ve already looked at the various settings that some people have posted. Just wondering if there’s any new info out there…

I run about 110-120 IPM @ 35 amps