Cutting holes in 1.25" square steel tube

[ds690]

@ben1272

I guess this also assumes the cut file opens up in the same location on the machine every time, which I dont even know yet about my own machine! If it does, this technique should work (assuming cuts can be turned on and off in SheetCam and/or FireControl.)

You tell the Firecontrol where to place the file on the machine by zeroing the X/Y on the spot where you want the Origin point of the drawing to be. There is no “home” position on the Crossfire and Crossfire Pro machines. Generally, you design with the Origin at the lower left corner of an imaginary square around the drawing. You can change that Origin location in Firecontrol, by using the “set program origin” button.