Crossfire XR THC touches off but keeps climbing (SOLVED)

The torch touches off on material (good ground) then raises to top out or until I STOP. It does not fire when this happens. I have ran the Fire control “Voltage Test” and all reads good. I can lower the torch and manually cut without issue. Please help with ideas or possible solutions, i.e bad limit switch, etc?
Hopefully video attaches. Thank you all again.

I recommend giving our engineer Cameron a call to discuss the details. The video didn’t attach, but you can send to him directly.

Thank you, I will do that.

I sent the email, but I tried to upload again? Thank you

Well, fixed again. When all else fails, reset THC in firecontrol

1 Like