Can’t jog Z axis up after finishing cut

CrossFire ® PRO
1

This is not really a big issue but after each complete cut I can’t jog the Z axis up or down. However, if I load a new program I am able to jog it up and down. However, if I bring it back to zero instead of loading a new program I can jog Z but when I jog it up it won’t stop and motor keeps turning after it’s at max height. I have to pull the USB to stop it. When I plug it back in everything resets and it’s all good. Any idea what causes this or is this just another software bug that will be fixed in an update?

2

@CadyRidah It’s a g-code issue…see my responses at the bottom of this thread for both SheetCAM and Fusion thanks! New Firmware installed and now new thc issues

3

Thanks so much! I’ll set my heights to match what it said and try it.

4

Make sure your THC is turned off at the end of the G-Code too. Should be an H0 command near the last M5…

5

This fixed the problem! Thanks again guys!

1 Like
6

Is this for 1.04 or 1.05? Im at 1.04 now and havent had this issue. I use sheetcam

7

I’m using 1.05

8

It’s a post issue, not a firmware issue.