All lines white in sheetcam

[VolvoFoShoBro]

I have been using sheet cam for only a few weeks, and I am a beginner to cam, and cnc. Everything was working fine, until today.

when I hit ok, or simulate on that screen then this happens.

However, this particular piece did cut correctly, but without lead ins. Any ideas? I wish I could just revert sheetcam back a day! I don’t know what I did to mess this program up.

[TomWS]

The object turned white because you’re in simulation mode. Click on the Arrow button to the left of the +S button above your object. It should go back to the other view.

[VolvoFoShoBro]

Doesn’t seem to be doing it.

[TomWS]

Well, I don’t know why your contours aren’t colored, but I do see you have Show Tool Paths and Show Segment Ends shut off.