.187 Thick 304 Stainless Settings

Unsupported
1

Making a cup holder for brother-in-law.

I have HT 45xp, good air (no gas) on a pro table with THC.
The cut charts do not provide for this thickness.

I found a remnant piece just big enough for two attempts so I can’t do much testing.
Looking for a starting point
Anyone have these settings?
I have reg. and fine cut available.

Capture2
Capture2343×637 3.8 KB

Cup Holder
Cup Holder841×612 34.5 KB

1 Like
2

This is the listing for Powermax45XP (AKA Hypertherm)

image
image661×699 142 KB

Powermax45XP Cut Charts.pdf (1.3 MB)

2 Likes
3

Oh crap, senior moment.
I was looking at the fine cut page which goes to 10 gage.
Thank you sir.

2 Likes