X Axis Gantry Alignment

[TomWS]

Welcome to the forum!

Check this thread… it’s a usuable method to align the X Axis…

First cut not square

Welcome to the forum! On the Crossfire original and the XL, with the cantilevered arm, you may have to check and adjust the X axis alignment with the Y. A 24" framing square should be good enough to find and correct this error. Drop the torch down to just touch a straight edge straddling the table along the Y axis, near 0,0. Move only Y direction to the max Y and rotate the straightedge so it just touches. Clamp it down and double check to see if it moved. Put your framing square along th…