Thank you for the information. I was able to successfully hard wire the plasma cutter. Got a little frustrating due to going back and forth on different forums how to do it, but I got it figured out, The color configuration is very easy to confuse. I’m a 12volt automotive technician, So by default RED means positive to me, LOL. which I thought its the torch side, and I thought, BLACK is ground thinking that it would be CLAMP side. I was sooooo WRONG. hahah. I almost cried thinking I just fried the THC module. Also didn’t know about the trigger wire. which was on a different forum, Razorweld was very kind to explain to me how to take it apart. My first attempt at taking it apart was not successful. After they explained it to me in (2 min) how it came apart easy. Mann such frustrating / stressful 2 days. But FINALLY it works. Now I’m research how to use Sheetcam / how to operate Firecontrol. Currently the post processor is uploaded, 1 tool setup has been done. and made my first successful cut. Of course the cuts don’t look great, But it cuts. Now I have to learn what all those setting’s are for, such as Kerf width, Feed rate , Pierce delay , etc.