Hello,
Has anyone had success cutting out a functional sprocket?
Circumstance:
-using #40 chain
-generated drawing from sprocketeer
-rhino>sheetcam>mach3
-would like to use 70 teeth or around that amount.
-cut outs are looking good but chain is not falling into the whole circumference
-ive spent time tuning bearings and adjusting xy table to square. cut out a square and measures square
-do not have a THC
-using hypertherm 45xp
-have tried this using 1/8" and 16 gauge, 3 times each, all do not gear in properly
I would upload a picture but “new users cant upload”<?
Any insight would be awesome.
Thanks Forum!