So I came to the garage for another try at diagnosing this machine. I checked the air dryer and filter, and both are good. I decided to open the new packs of electrodes and nozzles that I ordered with the crossfire table. After install, I tried the torch out and it seems to be cutting fine again. Only difference is that sometimes it makes a whistling noise while cutting. I verified that the swirl ring blows clockwise if looking at it from the torch side, not the tip. Any guesses? Maybe the consumables that came with the plasma cutter are different than the ones bought separately from razor weld? Also, are these electrodes the same 30 amp ones that came with it or are they 40 amp?