Pierce Delay issue on Mac

Software Fusion 360 - CAM
1

When posting on Fusion 360 for Mac, It won’t allow me to set a pierce delay for anything besides whole numbers. For example, I’m limited to 0,1,2,3,4… seconds. I’ve tried entering different values, such as “0.5”, “.5”, “0.500” It seems to not like having a decimal. I even tried “½”, to no avail. Any help is greatly appreciated.

2

I had the same problem so what I did clicked on the open post button at the bottom left of the post page and the program will open and you can change it there

1 Like
3

Had the same issue, can’t figure out why sometime it would let me do less than 1 and why sometime it doesn’t…very weird

4

Thanks! Got this worked out!

5

So what did you do to be able to find and change this? I’m having the same problem

thanks