My g code shows up in Firecontrol but no graphic

Software FireControl
1

Im guessing this is a software or driver issue. FC was running fine. yesterday I swapped out a new MC4000 BC the other one wasnt working. since doing the swap when I upload tap file only gcode shows up and no graphic on screen. I am running version 21.1.5 TIA

2

Update the video drivers.

1 Like
3

@njwrona Look in the top menu. there is a toggle for turning on and off the visualization.

1 Like
4

Thank you both. I’ll try these tomorrow when I get back in the shop