Just finished assembling the Xr and wanted to cut some test coupons without the water tray filled with as im going to make some modifications the drainage system also my water additive hasn’t shown up yet either.
Will the torch cut through the bottom of the water table if its used dry?
I wouldn’t cut in it without water.
If you want to do some test cutting you could get a cake pan and fill it up with water and just use that in one small spot for the time being.
Might have to remove a couple slats
DON’T DO IT!
That might work, thanks.
I figured it might distort or puncture the water pan
you’re welcome and Welcome to the forums by the way.
Make sure to post some of your projects on here when you get a chance.
Will do, thanks for the fast response, I’m eager to see this thing cut.