Errors with setup

Software Fusion 360 - CAD
1

Forgive me - I’m new at this

I am trying to create a test pattern with some text. I’m using stencil font. I am following along with the tutorial and THINK that I am doing everything the same way as he does it, but each and every time I click OK to create my cut pattern, I get an error and a part of my text is skipped. When I go through and select the lines to cut, I am selecting all of the lines, but one little part gets left off. It doesn’t seem to matter which order I select the lines. I’m kinda at a loss. I have tried the setup a dozen times and have received an error every time.

Is there any help for the Fusion 360?
Thanks,

2

The fusion forums can help with Fusion questions but lots of help here usually too.

Did you try extruding the surface and then picking it? You’ll find a lot of posts here on extruding and paths as a way to make sure you get the whole path.

1 Like