Crossfire Pro Detected as Crossfire in Firecut

CrossFire ® PRO
1

Hi Guys!

My Crossfire Pro is showing as a Crossfire in firecut with the smaller work area as a result…

is this normal ?? i’ve never paid attention before because i do mainly small parts, but was
stuck yesterday for a larger cut.

(looked on the forum for a related topic, did not found any…)

thanks for your insights!!!

2

Firecontrol always says “Crossfire” in the connection status, no matter which machine you have.

Firecontrol also doesn’t know the size of the table, unless you have limit switches.

3 Likes
3

Thanks i was not sure thank you for the info!

1 Like