Computer requirements question for PRO

So After I preordered I picked up a Computer to run it, XP 32bit lots of ram and memory,
from FAQ area

According to Fusion site I need a lot more than that to run fusion W10, 64bit etc. Which is fine I can use my current cad/cam and then maybe sheetcam for now.

MY questions is will the FireControl motion control software specifically developed for the PRO work with my setup?

I need to know if I need to get a computer before April, Thanks

ETA…grammar/spelling :crazy_face:

We are in the same boat…I can’t find any computer specs except the little note on FAQ. I don’t know what the other software will require…help!

Magic wand -----------------+ @langmuir-daniel

Not sure if @'s work here