I checked the feedarte chart, but do not see &can’t find a Feed Rate anywhere for 1/8" Aluminum using ViperWeld 30i.
Anyone using 1/8" aluminum?
Roughly 130ipm should be a good starting point at 30 amps
OK, thanks!!! I will give that a try.
I checked the feedarte chart, but do not see &can’t find a Feed Rate anywhere for 1/8" Aluminum using ViperWeld 30i.
Anyone using 1/8" aluminum?
Roughly 130ipm should be a good starting point at 30 amps
OK, thanks!!! I will give that a try.